by Carla Henton from Creatin’ in the Sticks
Size: Adult – one size fits most
HeatnBond® Soft Stretch™ LITE
StitchNSew™ fleece (small pieces for the applique)
1 Yard of fleece (blue)
1 cookie cutter (pattern for the applique)
11″ Dinner plate (or an 11″ circle template)
scissors, rotary cutter and mat, matching thread, sewing machine with zigzag stitch, walking foot for machine, iron, permanent marker, ruler, and basic sewing equipment.
Appliqued Fleece Hat and Scarf Instructions:
Cutting: from blue fleece
1 piece – 18″ x WOF (width of fabric)
2 – 11″ circles (just trace around a plate with a permanent marker and cut them out).
Fold circles in half and cut. This leaves 4 half circles.
4 – 5 1/2″ x 11″ strips
Trace cookie cutter on the paper side of HeatnBond Soft Stretch™ LITE. Trace 4, 2 for the scarf and 2 for the hat. If making flowers, trace a circle in the middle of the flowers. A bottle cap is perfect.
Fuse the HeatnBond® Soft Stretch™ LITE to StitchNSew™ fleece and cut out 4 flowers.
Constructing the Scarf:
Cut selvages off the 18″ x WOF (width of fabric) piece of blue fleece. On both ends measure 4 1/4″ from edge, this is where the center of the flower should be, and 5″ from end, this is where the bottom edge of the flower should be placed.
Peel the backing fabric off the flowers and bond to the scarf following the package instructions. Zigzag around the appliques.
Flatten scarf on ironing surface and press. Measure 5″ form each end and fold and press. This is a stitching line. Pin and stitch through both layers using a walking foot.
Create the fringe of the scarf by laying each end on the cutting mat and with a rotary cutter, cut into scarf from the end every 1/2″ up to 1/2″ from stitching.
Sew each 1/2 circle to 1 strip on the 11″ side, right sides together with 1/2″ seams making 4 half circle units. Press seams open.
Peel paper backing from appliques and place them on one of the half circle units right side, making sure to place it at least 1/2″ from the edge so it won’t be caught in the seam. Bond to fabric following the package instructions.
Zigzag around the applique as done with the scarf.
Pair 2 half circle units right sides together and pin around the curved edges. Repeat with the other pair. One pair (with the applique) is the outside of the hat and one pair is the lining. Leave a 2″ opening on the lining for turning right side out later. Stitch both pairs 1/2″ from edge around the curved edges.
Turn lining right side out and slide into outside hat piece. Matching seams, pin around the bottom of the hat.
Stitch 1/2″ from edge all around. Turn the hat right side out through the opening in the lining. Slip stitch the opening or sew a narrow seam with a sewing machine to close it. Tuck the lining into the hat and press. Top stitch around the bottom of the hat and it’s ready to wear.